150
8. Event Memory
The FA-9520 can store 100 event memories, as well as sets of settings, each of which are stored for
each format.
Every press of the EVENT button alternates the menus: EVENT LOAD (lit green), EVENT SAVE (lit
red)，and EVENT SETUP(lit orange). To go to the desired page, press the EVENT button a few
times, or press the EVENT button once and the up or down single arrow button to move between
EVENT pages.
8-1. EVENT LOAD
N O . : V I D E O F O R M A T
L O A D S T A R T F 2 U N I T Y
F O R M A T : 1 0 8 0 / 5 9 i
DEFAULT
*1
EVENT1 -
EVENT100
Selects the number of an event you
want to load.
LOAD ALL
LOAD FS1 ONLY
*2
LOAD FS2 ONLY
*2
Selects the event loading mode.
LOAD ALL: Loads all setting data
stored in events.
LOAD FS1 ONLY: Loads only FS1
setting data stored in events.
LOAD FS2 ONLY: Loads only FS2
setting data stored in events.
Loads the event that is selected
under MODE when the F3 UNITY
button is pressed.
*1 DEFAULT loads the default settings.
*2 Only the FS1 or FS2 settings that are shown with  or ⊚ in the menu list in section 4-2-2
“Menu Buttons“, and can be respectively set for FS1 and FS2. Other settings will always
be loaded regardless of the selected loading mode.
To Next Page
Loading...
Need help?
General
