74
5-9-6. ANC SET
A N C M O D E : H / V A N C
H A N C : O V E R W R I T E
Selects ancillary data processing mode for the
FS1 or FS2 output signal. H ANC and V ANC
menu settings will become available when H/V
ANC is selected.
DETAIL: Removes all H and V ancillary data,
and embeds newly specified ancillary data
(such as CC and AFD).
Set to DETAIL to enable settings in 5-7-4.
“ANC DATA EMBED” and 5-7-5. “ANC
EMBED LINE”.
Embeds audio signals into horizontal ancillary
data of FS1 or FS2 output videos.
OVERWRITE: Removes the embedded audio
signal from the input SDI video signal, then
embeds the processed audio data on the
video signal. Whether to embed is determined
by the AUDIO GROUP setting in
section 5-10-10 “EMB 1 IN AUDIO”.
The input SDI data will be embedded on the
video signal after audio signals are embedded.
IN DATA: Passes the input SDI horizontal
ancillary data without processing. (Processed
audio data cannot be embedded.)
BLANK: Deletes all horizontal ancillary data,
and embeds the processed audio data.
Embeds audio signals into vertical ancillary
data of FS1 or FS2 output videos.
PASS: Embeds the vertical ancillary data
without processing.
BLANK: Deletes all vertical ancillary data.
* Settings can be set for FS1 and FS2, respectively.
* H ANC and V ANC settings become available when ANC MODE is set to H/V ANC. H ANC
and V ANC settings are effective if input and output formats are the same. If such formats
are different, both H ANC and V ANC will be set to BLANK.
To Next Page
Loading...
