FOR-A FA-9520 - To Embed Analog Audio Signals on SDI Signals

25
3-4. To Embed Analog Audio Signals on SDI Signals
The following describes how to embed a 4- channel analog audio signal on SDI OUT1 and 2
output signals.
Settings that need to be checked:
 Set FS1 IN SEL to SDI1 in the FS INPUT SELECT menu (see section 5-6-1).
 Set SDI 1/2 to FS1 in the OUTPUT ASSIGN menu (see section 5-7-1).
 Set CH1 through CH4 to ANALOG CH1 through CH4 respectively in the EMB1 OUT REMAP
menu (see section 6-5-1).
NOTE
See section 12 "Analog Audio Connection” for the ANALOG AUDIO connector
connection.
Change audio settings, if necessary, in the ANALOG AUDIO Settings (ANALOG)
menu (section 6-3).
REMOTE
LAN1
COMPOSITE
OUT3OUT2IN1
SDI
ANALOG AUDIO
LAN2
IO1/2
DIGITAL AUDIO
OUT4OUT1 IN2
FAN2
IO3/4
IO5/6
IO7/8
GENLOCK IN
FAN1
OUT1 OUT2IN
Input audio signals to ANALOG
AUDIO IN1 - 4 channels.
The Analog audio signals are
embedded to AUDIO CH 1 through 4 of
output signals from SDI OUT1 and 2.
Input an HD/SD-SDI
signal to SDI IN1.