FOR-A FA-9520 - Conv Side Rgb

45
5-3-6. CONV SIDE RGB
C O N V S I D E R G B
10
R E D : 0
G R E E N : 0
B L U E : 0
G R O U P A D J U S T
Parameter
Default
Setting range
Description
RED, GREEN, BLUE
(Background color)
0
0 - 255
Sets background color that will be visible if
the converted image is set smaller than
original in CONV SIZE/POS (5-3-3).
R, G, and B components can be adjusted
separately.
F4 control knob allows you to adjust R, G,
and B at the same time.
Group Adjust
(Group Adjustment)
0
0 - 255
Adjusts the R, G, and B components
separately, then turns this Group Adjust
on. Changing any R, G, or B value will
change the values of the three
components accordingly while retaining
the proportion.
* Settings can be set for FS1 and FS2, respectively.
If the CONV mode is set to BY-PASS, the CONV SIDE RGB setting cannot be changed. Also,
it cannot be changed if the conversion is set to the formats indicated as (BY-PASS) in the
CONV Conversion Table (see section 5-3-2). In both cases, the menu as shown below will be
displayed.
C O N V I M P R O V E
10
R E D : N O T A D J U S T
G R E E N : N O T A D J U S T
B L U E : N O T A D J U S T
FS1/LOCK
FS2/LOCK
Menu button
CONV1
ANALOG