70
Table of Reference signals and Input formats that can lock
✓✓✓: SYNCHRO can be set to FRAME, LINE, or AVDL.
✓: SYNCHRO can only be set to FRAME.
-: Unable to synchronize.
5-9-2. HD PHASE SET
H 1080
*1
(Horizontal Phase)
Adjusts the horizontal and
vertical phases of the
system referring to genlock
signal. This setting is
applied to 1080-format
output signals.
V 1080
*1
(Vertical Phase)
0
*2
(FRAME)
1
*2
(LINE,AVDL)
H 720
*1
(Horizontal Phase)
Adjusts the horizontal and
vertical phases of the
system referring to genlock
signal. This setting is
applied to 720-format
output signals.
V 720
*1
(Vertical Phase)
0
*2
(FRAME)
1
*2
(LINE,AVDL)
*1 The settings are not available if there is no reference signal input. In such case, the menu
as shown below will be displayed.
H 1 0 8 0 : N O T A D J U S T
V 1 0 8 0 : N O T A D J U S T
H 7 2 0 : N O T A D J U S T
V 7 2 0 : N O T A D J U S T
*2 The default value varies depending on the SYNCHRO setting in section 5-9-1 “FS MODE
SET” and the setting in section 5-6-1 “FS INPUT SELECT” as shown in the below table.
The set value will be reset to its relevant default value whenever the SYNCHRO setting is
changed.
To Next Page
Loading...
