Common (*) Commands 5
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 111
*CLS (Clear Status)
(see page 798)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the device-defined
error queue, and the Request-for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 109
• "*STB (Read Status Byte)" on page 127
• "*ESE (Standard Event Status Enable)" on page 112
• "*ESR (Standard Event Status Register)" on page 114
• "*SRE (Service Request Enable)" on page 125
• ":SYSTem:ERRor" on page 551
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.
To Next Page
Loading...
