Keysight Technologies InfiniiVision DSOX1204G

280 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
16 :FRANalysis Commands
:FRANalysis:FREQuency:STOP
(see page 798)
Command Syntax
:FRANalysis:FREQuency:STOP <value>[suffix]
<value> ::= between 10.1 Hz and 20 MHz with a resolution of 0.1 Hz
in NR3 format
[suffix] ::= {Hz | kHz| MHz}
The :FRANalysis:FREQuency:STOP command sets the frequency sweep stop value.
Query Syntax
:FRANalysis:FREQuency:STOP?
The :FRANalysis:FREQuency:STOP? query returns the frequency sweep stop
setting.
Return Format
<value><NL>
See Also • ":FRANalysis:DATA" on page 275
• ":FRANalysis:ENABle" on page 276
• ":FRANalysis:FREQuency:STARt" on page 279
• ":FRANalysis:SWEep:POINts" on page 284
• ":FRANalysis:FREQuency:MODE" on page 277
• ":FRANalysis:RUN" on page 281
• ":FRANalysis:SOURce:INPut" on page 282
• ":FRANalysis:SOURce:OUTPut" on page 283
• ":FRANalysis:WGEN:LOAD" on page 286
• ":FRANalysis:WGEN:VOLTage" on page 287