456 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
23 :SAVE Commands
:SAVE:WAVeform:LENGth
(see page 798)
Command Syntax
:SAVE:WAVeform:LENGth <length>
<length> ::= 100 to max. length; an integer in NR1 format
When the :SAVE:WAVeform:LENGth:MAX setting is OFF, the
:SAVE:WAVeform:LENGth command sets the waveform data length (that is, the
number of points saved).
When the :SAVE:WAVeform:LENGth:MAX setting is ON, the
:SAVE:WAVeform:LENGth setting has no effect.
Query Syntax
:SAVE:WAVeform:LENGth?
The :SAVE:WAVeform:LENGth? query returns the current waveform data length
setting.
Return Format
<length><NL>
<length> ::= 100 to max. length; an integer in NR1 format
See Also • "Introduction to :SAVE Commands" on page 442
• ":SAVE:WAVeform:LENGth:MAX" on page 457
• ":SAVE:WAVeform[:STARt]" on page 454
• ":WAVeform:POINts" on page 645
• ":SAVE:WAVeform:FORMat" on page 455
To Next Page
Loading...
