To Next Page

To Previous Page

:MTESt Commands 21

Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 407

:MTESt:AMASk:UNITs

(see page 798)

Command Syntax

:MTESt:AMASk:UNITs <units>

<units> ::= {CURRent | DIVisions}

The :MTESt:AMASk:UNITs command alters the way the mask test subsystem

interprets the tolerance parameters for automasking as defined by

:MTESt:AMASk:XDELta and :MTESt:AMASk:YDELta commands.

• CURRent — the mask test subsystem uses the units as set by the

:CHANnel<n>:UNITs command, usually time for

ΔX and voltage for ΔY.

• DIVisions — the mask test subsystem uses the graticule as the measurement

system, so tolerance settings are specified as parts of a screen division. The

mask test subsystem maintains separate XDELta and YDELta settings for

CURRent and DIVisions. Thus, XDELta and YDELta are not converted to new

values when the UNITs setting is changed.

Query Syntax

:MTESt:AMASk:UNITs?

The :MTESt:AMASk:UNITs query returns the current measurement units setting for

the mask test automask feature.

Return Format

<units> ::= {CURR | DIV}

See Also • "Introduction to :MTESt Commands" on page 401

• ":MTESt:AMASk:XDELta" on page 408

• ":MTESt:AMASk:YDELta" on page 409

• ":CHANnel<n>:UNITs" on page 220

• ":MTESt:AMASk:SOURce" on page 406

• ":MTESt:SOURce" on page 431

Example Code • "Example Code" on page 401

Keysight Technologies InfiniiVision DSOX1204G User Manual

Questions and Answers: