Obsolete and Discontinued Commands 31
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 743
:MEASure:VSTOp
(see page 798)
Command Syntax
:MEASure:VSTOp <vstop_argument>
<vstop_argument> ::= value for Y2 cursor
The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to the
specified value corresponding to the selected source. The source can be selected
by the MARKer:X2Y2source command.
Query Syntax
:MEASure:VSTOp?
The :MEASure:VSTOp? query returns the current value of the Y2 cursor.
Return Format
<value><NL>
<value> ::= value of the Y2 cursor in NR3 format
See Also • "Introduction to :MARKer Commands" on page 326
• "Introduction to :MEASure Commands" on page 350
• ":MARKer:Y1Position" on page 336
• ":MARKer:Y2Position" on page 337
• ":MARKer:YDELta" on page 338
• ":MARKer:X2Y2source" on page 332
• ":MEASure:SOURce" on page 380
• ":MEASure:TDELta" on page 733
• ":MEASure:TSTArt" on page 737
The short form of this command, VSTO, does not follow the defined Long Form to Short Form
Truncation Rules (see page 800). The normal short form, VST, would be the same for both
VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.
The :MEASure:VSTOp command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:Y2Position command (see page 337) instead.
To Next Page
Loading...
Need help?
General
