514 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
:SBUS<n>:SPI:SOURce:FRAMe
(see page 798)
Command Syntax
:SBUS<n>:SPI:SOURce:FRAMe <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:SPI:SOURce:FRAMe command sets the frame source when
:SBUS<n>:SPI:FRAMing is set to CHIPselect or NOTChipselect.
Query Syntax
:SBUS<n>:SPI:SOURce:FRAMe?
The :SBUS<n>:SPI:SOURce:FRAMe? query returns the current frame source for the
SPI serial frame.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":SBUS<n>:SPI:SOURce:CLOCk" on page 513
• ":SBUS<n>:SPI:SOURce:MOSI" on page 516
• ":SBUS<n>:SPI:SOURce:MISO" on page 515
• ":SBUS<n>:SPI:FRAMing" on page 512
To Next Page
Loading...
