302 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
17 :FUNCtion Commands
:FUNCtion:OFFSet
(see page 798)
Command Syntax
:FUNCtion:OFFSet <offset>
<offset> ::= the value at center screen in NR3 format.
The :FUNCtion:OFFSet command sets the voltage or vertical value represented at
center screen for the selected function. The range of legal values is generally
+/-10 times the current scale of the selected function, but will vary by function. If
you set the offset to a value outside of the legal range, the offset value is
automatically set to the nearest legal value.
Query Syntax
:FUNCtion:OFFSet?
The :FUNCtion:OFFSet? query outputs the current offset value for the selected
function.
Return Format
<offset><NL>
<offset> ::= the value at center screen in NR3 format.
See Also • "Introduction to :FUNCtion Commands" on page 291
• ":FUNCtion:RANGe" on page 305
• ":FUNCtion:REFerence" on page 306
• ":FUNCtion:SCALe" on page 307
The :FUNCtion:OFFset command is equivalent to the :FUNCtion:REFerence command.
To Next Page
Loading...
Need help?
General
