694 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
29 :WGEN Commands
:WGEN:PERiod
(see page 798)
Command Syntax
<period> ::= period in seconds in NR3 format
For all waveforms except Noise and DC, the :WGEN:PERiod command specifies
the period of the waveform.
You can also specify the period indirectly using the :WGEN:FREQuency command.
Query Syntax
:WGEN:PERiod?
The :WGEN:PERiod? query returns the currently set waveform generator period.
Return Format
<period><NL>
<period> ::= period in seconds in NR3 format
See Also • "Introduction to :WGEN Commands" on page 671
• ":WGEN:FUNCtion" on page 673
• ":WGEN:FREQuency" on page 672
To Next Page
Loading...
