216 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
10 :CHANnel<n> Commands
:CHANnel<n>:PROBe:STYPe
(see page 798)
Command Syntax
:CHANnel<n>:PROBe:STYPe <signal type>
<signal type> ::= {DIFFerential | SINGle}
<n> ::= 1 to (# analog channels) in NR1 format
The :CHANnel<n>:PROBe:STYPe command sets the channel probe signal type
(STYPe) to differential or single-ended when using the 113xA Series probes and
determines how offset is applied.
When single-ended is selected, the :CHANnel<n>:OFFset command changes the
offset value of the probe amplifier. When differential is selected, the
:CHANnel<n>:OFFset command changes the offset value of the channel amplifier.
Query Syntax
:CHANnel<n>:PROBe:STYPe?
The :CHANnel<n>:PROBe:STYPe? query returns the current probe signal type
setting for the selected channel.
Return Format
<signal type><NL>
<signal type> ::= {DIFF | SING}
See Also • "Introduction to :CHANnel<n> Commands" on page 203
• ":CHANnel<n>:OFFSet" on page 211
This command is valid only for the 113xA Series probes.
To Next Page
Loading...
Need help?
General
