476 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
:SBUS<n>:CAN:SOURce
(see page 798)
Command Syntax
:SBUS<n>:CAN:SOURce <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:CAN:SOURce command sets the source for the CAN signal.
Query Syntax
:SBUS<n>:CAN:SOURce?
The :SBUS<n>:CAN:SOURce? query returns the current source for the CAN signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":SBUS<n>:MODE" on page 465
• ":SBUS<n>:CAN:TRIGger" on page 477
• ":SBUS<n>:CAN:SIGNal:DEFinition" on page 475
To Next Page
Loading...
