282 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
16 :FRANalysis Commands
:FRANalysis:SOURce:INPut
(see page 798)
Command Syntax
:FRANalysis:SOURce:INPut <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :FRANalysis:SOURce:INPut command specifies the analog input channel that
is probing the input voltage to the device under test (DUT) in the frequency
response analysis.
Query Syntax
:FRANalysis:SOURce:INPut?
The :FRANalysis:SOURce:INPut? query returns the currently selected channel
probing the input voltage.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • ":FRANalysis:DATA" on page 275
• ":FRANalysis:ENABle" on page 276
• ":FRANalysis:FREQuency:STARt" on page 279
• ":FRANalysis:FREQuency:STOP" on page 280
• ":FRANalysis:RUN" on page 281
• ":FRANalysis:SOURce:OUTPut" on page 283
• ":FRANalysis:WGEN:LOAD" on page 286
• ":FRANalysis:WGEN:VOLTage" on page 287
To Next Page
Loading...
