Keysight Technologies InfiniiVision DSOX1204G

191
Keysight InfiniiVision DSOX1204A/G Oscilloscopes
Programmer's Guide
9 :CALibrate Commands
Utility commands for viewing calibration status and for starting the user
calibration procedure. See "Introduction to :CALibrate Commands" on page 192.
Table 54 :CALibrate Commands Summary
Command Query Options and Query Returns
n/a :CALibrate:DATE? (see
page 193)
<return value> ::=
<year>,<month>,<day>; all in NR1
format
:CALibrate:LABel
<string> (see
page 194)
:CALibrate:LABel?
(see page 194)
<string> ::= quoted ASCII string
up to 32 characters
:CALibrate:OUTPut
<signal> (see
page 195)
:CALibrate:OUTPut?
(see page 195)
<signal> ::= {TRIGgers | MASK |
WAVEgen}
n/a :CALibrate:PROTected?
(see page 196)
{"PROTected" | "UNPRotected"}
:CALibrate:STARt (see
page 197)
n/a n/a
n/a :CALibrate:STATus?
(see page 198)
<return value> ::=
<status_code>,<status_string>
<status_code> ::= an integer
status code
<status_string> ::= an ASCII
status string
n/a :CALibrate:TEMPeratur
e? (see page 199)
<return value> ::= degrees C
delta since last cal in NR3
format
n/a :CALibrate:TIME? (see
page 200)
<return value> ::=
<hours>,<minutes>,<seconds>; all
in NR1 format