:WGEN Commands 29
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 685
:WGEN:MODulation:FUNCtion
(see page 798)
Command Syntax
:WGEN:MODulation:FUNCtion <shape>
<shape> ::= {SINusoid | SQUare| RAMP}
The :WGEN:MODulation:FUNCtion command specifies the shape of the
modulating signal.
When the RAMP shape is selected, you can specify the amount of time per cycle
that the ramp waveform is rising with the
:WGEN:MODulation:FUNCtion:RAMP:SYMMetry command.
This command applies to AM and FM modulation. (The FSK modulation signal is a
square wave shape.)
Query Syntax
:WGEN:MODulation:FUNCtion?
The :WGEN:MODulation:FUNCtion? query returns the specified modulating signal
shape.
Return Format
<shape><NL>
<shape> ::= {SIN | SQU| RAMP}
See Also • ":WGEN:MODulation:AM:DEPTh" on page 679
• ":WGEN:MODulation:AM:FREQuency" on page 680
• ":WGEN:MODulation:FM:DEViation" on page 681
• ":WGEN:MODulation:FM:FREQuency" on page 682
• ":WGEN:MODulation:FSKey:FREQuency" on page 683
• ":WGEN:MODulation:FSKey:RATE" on page 684
• ":WGEN:MODulation:FUNCtion:RAMP:SYMMetry" on page 686
• ":WGEN:MODulation:STATe" on page 688
• ":WGEN:MODulation:TYPE" on page 689
To Next Page
Loading...
Need help?
General
