Keysight Technologies InfiniiVision DSOX1204G

622 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
27 :TRIGger Commands
:TRIGger:TRANsition Commands
The :TRIGger:TRANsition commands set the rise/fall time trigger options.
NOTE
The :TRIGger:TRANsition commands are available on the DSOX1000-Series oscilloscopes
only.
Table 82 :TRIGger:TRANsition Commands Summary
Command Query Options and Query Returns
:TRIGger:TRANsition:Q
UALifier <qualifier>
(see page 623)
:TRIGger:TRANsition:Q
UALifier? (see
page 623)
<qualifier> ::= {GREaterthan |
LESSthan}
:TRIGger:TRANsition:S
LOPe <slope> (see
page 624)
:TRIGger:TRANsition:S
LOPe? (see page 624)
<slope> ::= {NEGative | POSitive}
:TRIGger:TRANsition:S
OURce <source> (see
page 625)
:TRIGger:TRANsition:S
OURce? (see page 625)
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels)
in NR1 format
:TRIGger:TRANsition:T
IME <time>[suffix]
(see page 626)
:TRIGger:TRANsition:T
IME? (see page 626)
<time> ::= floating-point number
in NR3 format
[suffix] ::= {s | ms | us | ns |
ps}