Keysight Technologies InfiniiVision DSOX1204G

750 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
31 Obsolete and Discontinued Commands
:MTESt:{STARt | STOP}
(see page 798)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition system.
See Also • "Introduction to :MTESt Commands" on page 401
NOTE
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for backward
compatibility to previous oscilloscopes. Use the :RUN command (see page 159) and :STOP
command (see page 163) instead.