:SBUS<n> Commands 24
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 529
:SBUS<n>:UART:COUNt:RESet
(see page 798)
Command Syntax
:SBUS<n>:UART:COUNt:RESet
Resets the UART frame counters.
Errors • "-241, Hardware missing" on page 759
See Also • ":SBUS<n>:UART:COUNt:ERRor" on page 528
• ":SBUS<n>:UART:COUNt:RXFRames" on page 530
• ":SBUS<n>:UART:COUNt:TXFRames" on page 531
• "Introduction to :SBUS<n> Commands" on page 461
• ":SBUS<n>:MODE" on page 465
• ":SBUS<n>:UART Commands" on page 523
To Next Page
Loading...
