226 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
11 :DEMO Commands
:DEMO:OUTPut
(see page 798)
Command Syntax
:DEMO:OUTPut <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}
The :DEMO:OUTPut command specifies whether the demo signal output is ON (1)
or OFF (0).
Query Syntax
:DEMO:OUTPut?
The :DEMO:OUTPut? query returns the current state of the demo signal output
setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :DEMO Commands" on page 223
• ":DEMO:FUNCtion" on page 224
To Next Page
Loading...
