:SAVE Commands 23
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 453
:SAVE:SETup[:STARt]
(see page 798)
Command Syntax
:SAVE:SETup[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE:SETup[:STARt] command saves an oscilloscope setup.
See Also • "Introduction to :SAVE Commands" on page 442
• ":SAVE:FILename" on page 444
• ":RECall:SETup[:STARt]" on page 438
If a file extension is provided as part of a specified <file_name>, it must be ".scp".
To Next Page
Loading...
