438 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
22 :RECall Commands
:RECall:SETup[:STARt]
(see page 798)
Command Syntax
:RECall:SETup[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:SETup[:STARt] command recalls an oscilloscope setup.
See Also • "Introduction to :RECall Commands" on page 433
• ":RECall:FILename" on page 435
• ":SAVE:SETup[:STARt]" on page 453
If a file extension is provided as part of a specified <file_name>, it must be ".scp".
To Next Page
Loading...
