:TRIGger Commands 27
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 593
:TRIGger:LEVel:LOW
(see page 798)
Command Syntax
:TRIGger:LEVel:LOW <level>, <source>
<level> ::= 0.75 x full-scale voltage from center screen in NR3 format
for internal triggers
<source> ::= {CHANnel<n> | EXTernal}
<n> ::= 1 to (# analog channels) in NR1 format
The :TRIGger:LEVel:LOW command sets the low trigger voltage level voltage for
the specified source.
Query Syntax
:TRIGger:LEVel:LOW? <source>
The :TRIGger:LEVel:LOW? query returns the low trigger voltage level for the
specified source.
Return Format
<level><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":TRIGger:LEVel:HIGH" on page 592
• ":TRIGger[:EDGE]:SOURce" on page 602
To Next Page
Loading...
