:WGEN Commands 29
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 691
:WGEN:OUTPut
(see page 798)
Command Syntax
:WGEN:OUTPut <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN:OUTPut command specifies whether the waveform generator signal
output is ON (1) or OFF (0).
Query Syntax
:WGEN:OUTPut?
The :WGEN:OUTPut? query returns the current state of the waveform generator
output setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :WGEN Commands" on page 671
To Next Page
Loading...
