Keysight Technologies InfiniiVision DSOX1204G

:WGEN Commands 29
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 689
:WGEN:MODulation:TYPE
(see page 798)
Command Syntax
:WGEN:MODulation:TYPE <type>
<type> ::= {AM | FM | FSK}
The :WGEN:MODulation:TYPE command selects the modulation type:
• AM (amplitude modulation) — the amplitude of the original carrier signal is
modified according to the amplitude of the modulating signal.
Use the :WGEN:MODulation:AM:FREQuency command to set the modulating
signal frequency.
Use the :WGEN:MODulation:AM:DEPTh command to specify the amount of
amplitude modulation.
• FM (frequency modulation) — the frequency of the original carrier signal is
modified according to the amplitude of the modulating signal.
Use the :WGEN:MODulation:FM:FREQuency command to set the modulating
signal frequency.
Use the :WGEN:MODulation:FM:DEViation command to specify the frequency
deviation from the original carrier signal frequency.
• FSK (frequency-shift keying modulation) — the output frequency "shifts"
between the original carrier frequency and a "hop frequency" at the specified
FSK rate.
The FSK rate specifies a digital square wave modulating signal.
Use the :WGEN:MODulation:FSKey:FREQuency command to specify the "hop
frequency".
Use the :WGEN:MODulation:FSKey:RATE command to specify the rate at which
the output frequency "shifts".
Query Syntax
:WGEN:MODulation:TYPE?
The :WGEN:MODulation:TYPE? query returns the selected modulation type.
Return Format
<type><NL>
<type> ::= {AM | FM | FSK}
See Also • ":WGEN:MODulation:AM:DEPTh" on page 679
• ":WGEN:MODulation:AM:FREQuency" on page 680
• ":WGEN:MODulation:FM:DEViation" on page 681
• ":WGEN:MODulation:FM:FREQuency" on page 682
• ":WGEN:MODulation:FSKey:FREQuency" on page 683