Root (:) Commands 6
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 159
:RUN
(see page 798)
Command Syntax
:RUN
The :RUN command starts repetitive acquisitions. This is the same as pressing the
Run key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 135
• ":SINGle" on page 161
• ":STOP" on page 163
Example Code
' RUN_STOP - (not executed in this example)
' - RUN starts the data acquisition for the active waveform display.
' - STOP stops the data acquisition and turns off AUTOSTORE.
' myScope.WriteString ":RUN" ' Start data acquisition.
' myScope.WriteString ":STOP" ' Stop the data acquisition.
See complete example programs at: Chapter 36, “Programming Examples,”
starting on page 807
To Next Page
Loading...
