Obsolete and Discontinued Commands 31
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 733
:MEASure:TDELta
(see page 798)
Query Syntax
:MEASure:TDELta?
The :MEASure:TDELta? query returns the time difference between the Tstop
marker (X2 cursor) and the Tstart marker (X1 cursor).
Tdelta = Tstop - Tstart
Tstart is the time at the start marker (X1 cursor) and Tstop is the time at the stop
marker (X2 cursor). No measurement is made when the :MEASure:TDELta? query
is received by the oscilloscope. The delta time value that is output is the current
value. This is the same value as the front-panel cursors delta X value.
Return Format
<value><NL>
<value> ::= time difference between start and stop markers in NR3 format
See Also • "Introduction to :MARKer Commands" on page 326
• "Introduction to :MEASure Commands" on page 350
• ":MARKer:X1Position" on page 329
• ":MARKer:X2Position" on page 331
• ":MARKer:XDELta" on page 333
• ":MEASure:TSTArt" on page 737
• ":MEASure:TSTOp" on page 738
The :MEASure:TDELta command is an obsolete command provided for compatibility to
previous oscilloscopes. Use the :MARKer:XDELta command (see page 333) instead.
To Next Page
Loading...
Need help?
General
