Keysight Technologies InfiniiVision DSOX1204G

325
Keysight InfiniiVision DSOX1204A/G Oscilloscopes
Programmer's Guide
19 :MARKer Commands
Set and query the settings of X-axis markers (X1 and X2 cursors) and the Y-axis
markers (Y1 and Y2 cursors). See "Introduction to :MARKer Commands" on
page 326.
Table 64 :MARKer Commands Summary
Command Query Options and Query Returns
:MARKer:MODE <mode>
(see page 328)
:MARKer:MODE? (see
page 328)
<mode> ::= {OFF | MEASurement |
MANual | WAVeform}
:MARKer:X1Position
<position>[suffix]
(see page 329)
:MARKer:X1Position?
(see page 329)
<position> ::= X1 cursor position
value in NR3 format
[suffix] ::= {s | ms | us | ns |
ps | Hz | kHz | MHz}
<return_value> ::= X1 cursor
position value in NR3 format
:MARKer:X1Y1source
<source> (see
page 330)
:MARKer:X1Y1source?
(see page 330)
<source> ::= {CHANnel<n> |
FUNCtion | MATH | FFT |
WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<r> ::= 1-2 in NR1 format
<return_value> ::= <source>
:MARKer:X2Position
<position>[suffix]
(see page 331)
:MARKer:X2Position?
(see page 331)
<position> ::= X2 cursor position
value in NR3 format
[suffix] ::= {s | ms | us | ns |
ps | Hz | kHz | MHz}
<return_value> ::= X2 cursor
position value in NR3 format