:ABUS Commands 7
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 173
:ABUS:DISPlay
(see page 798)
Command Syntax
:ABUS:DISPlay <value>
<value> ::= {{1 | ON} | {0 | OFF}}
The :ABUS:DISPlay command enables or disables the view of the selected bus.
Query Syntax
:ABUS:DISPlay?
The :ABUS:DISPlay? query returns the display value of the selected bus.
Return Format
<value><NL>
<value> ::= {0 | 1}
See Also • "Introduction to :ABUS Commands" on page 168
• ":ABUS:BIT<m>" on page 169
• ":ABUS:BITS" on page 170
• ":ABUS:CLEar" on page 172
• ":ABUS:LABel" on page 174
• ":ABUS:MASK" on page 175
To Next Page
Loading...
