:SBUS<n> Commands 24
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 543
:SBUS<n>:UART:WIDTh
(see page 798)
Command Syntax
:SBUS<n>:UART:WIDTh <width>
<width> ::= {5|6|7|8|9}
The :SBUS<n>:UART:WIDTh command determines the number of bits (5-9) for
each message "byte" for the serial decoder and/or trigger when in UART mode.
Query Syntax
:SBUS<n>:UART:WIDTh?
The :SBUS<n>:UART:WIDTh? query returns the current UART width setting.
Return Format
<width><NL>
<width> ::= {5|6|7|8|9}
See Also • "Introduction to :TRIGger Commands" on page 585
• ":TRIGger:MODE" on page 594
• ":SBUS<n>:UART:TRIGger:TYPE" on page 542
To Next Page
Loading...
