672 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
29 :WGEN Commands
:WGEN:FREQuency
(see page 798)
Command Syntax
:WGEN:FREQuency <frequency>
<frequency> ::= frequency in Hz in NR3 format
For all waveforms except Noise and DC, the :WGEN:FREQuency command
specifies the frequency of the waveform.
You can also specify the frequency indirectly using the :WGEN:PERiod command.
Query Syntax
:WGEN:FREQuency?
The :WGEN:FREQuency? query returns the currently set waveform generator
frequency.
Return Format
<frequency><NL>
<frequency> ::= frequency in Hz in NR3 format
See Also • "Introduction to :WGEN Commands" on page 671
• ":WGEN:FUNCtion" on page 673
• ":WGEN:PERiod" on page 694
To Next Page
Loading...
