Keysight Technologies InfiniiVision DSOX1204G

Common (*) Commands 5
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 125
*SRE (Service Request Enable)
(see page 798)
Command Syntax
*SRE <mask>
<mask> ::= integer with values defined in the following table.
The *SRE command sets the bits in the Service Request Enable Register. The
Service Request Enable Register contains a mask value for the bits to be enabled
in the Status Byte Register. A one in the Service Request Enable Register enables
the corresponding bit in the Status Byte Register. A zero disables the bit.
From
Operati on
Status
Registers
10234567

OPER TRGMAVESB
RQS /
MSS
TRG
Reg
TER? Trigger Event Register
*SRE
*SRE?
*STB? Statu s Byte Register
Service Request Enable
(Mask) Register
Outp ut
Queue
SRQ
From
Standard
Event
Status
Registers
USR
MSG
Service Request
OR