Keysight Technologies InfiniiVision DSOX1204G

:SBUS<n> Commands 24
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 521
:SBUS<n>:SPI:TRIGger:TYPE
(see page 798)
Command Syntax
:SBUS<n>:SPI:TRIGger:TYPE <value>
<value> ::= {MOSI | MISO}
The :SBUS<n>:SPI:TRIGger:TYPE command specifies whether the SPI trigger will
be on the MOSI data or the MISO data.
When triggering on MOSI data, the data value is specified by the
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA and
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh commands.
When triggering on MISO data, the data value is specified by the
:SBUS<n>:SPI:TRIGger:PATTern:MISO:DATA and
:SBUS<n>:SPI:TRIGger:PATTern:MISO:WIDTh commands.
Query Syntax
:SBUS<n>:SPI:TRIGger:TYPE?
The :SBUS<n>:SPI:TRIGger:TYPE? query returns the current SPI trigger type
setting.
Return Format
<value><NL>
<value> ::= {MOSI | MISO}
See Also • "Introduction to :TRIGger Commands" on page 585
• ":SBUS<n>:SPI:SOURce:MOSI" on page 516
• ":SBUS<n>:SPI:SOURce:MISO" on page 515
• ":SBUS<n>:SPI:TRIGger:PATTern:MISO:DATA" on page 517
• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA" on page 519
• ":SBUS<n>:SPI:TRIGger:PATTern:MISO:WIDTh" on page 518
• ":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh" on page 520
• ":TRIGger:MODE" on page 594