536 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
:SBUS<n>:UART:SOURce:TX
(see page 798)
Command Syntax
:SBUS<n>:UART:SOURce:TX <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:UART:SOURce:TX command controls which signal is used as the Tx
source by the serial decoder and/or trigger when in UART mode.
Query Syntax
:SBUS<n>:UART:SOURce:TX?
The :SBUS<n>:UART:SOURce:TX? query returns the current source for the UART
Tx signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":TRIGger:MODE" on page 594
• ":SBUS<n>:UART:TRIGger:TYPE" on page 542
• ":SBUS<n>:UART:BITorder" on page 527
To Next Page
Loading...
