To Next Page

To Previous Page

:MARKer Commands 19

Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 331

:MARKer:X2Position

(see page 798)

Command Syntax

:MARKer:X2Position <position> [suffix]

<position> ::= X2 cursor position in NR3 format

<suffix> ::= {s | ms | us | ns | ps | Hz | kHz | MHz}

The :MARKer:X2Position command:

• Sets :MARKer:MODE to MANual if it is not currently set to WAVeform (see

":MARKer:MODE" on page 328).

• Sets the X2 cursor position to the specified value.

X cursor units are set by the :MARKer:XUNits command.

Query Syntax

:MARKer:X2Position?

The :MARKer:X2Position? query returns current X2 cursor position. This is

functionally equivalent to the obsolete :MEASure:TSTOp command/query.

Return Format

<position> ::= X2 cursor position in NR3 format

See Also • "Introduction to :MARKer Commands" on page 326

• ":MARKer:MODE" on page 328

• ":MARKer:X1Position" on page 329

• ":MARKer:X2Y2source" on page 332

• ":MARKer:XUNits" on page 334

• ":MEASure:TSTOp" on page 738

NOTE

If the front-panel cursors are off, the marker position values are not defined and an error is

generated. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors in the

front-panel Normal mode.

Keysight Technologies InfiniiVision DSOX1204G User Manual

Questions and Answers: