:TRIGger Commands 27
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 619
:TRIGger:SHOLd:SOURce:DATA
(see page 798)
Command Syntax
:TRIGger:SHOLd:SOURce:DATA <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :TRIGger:SHOLd:SOURce:DATA command selects the input channel probing
the data signal.
Query Syntax
:TRIGger:SHOLd:SOURce:DATA?
The :TRIGger:SHOLd:SOURce:DATA? query returns the currently set data signal
source.
Return Format
<source><NL>
<source> ::= {CHAN<n>}
See Also • "Introduction to :TRIGger Commands" on page 585
• ":TRIGger:MODE" on page 594
• ":TRIGger:SHOLd:SLOPe" on page 617
To Next Page
Loading...
