:MARKer Commands 19
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 339
:MARKer:YUNits
(see page 798)
Command Syntax
:MARKer:YUNits <units>
<units> ::= {BASE | PERCent}
The :MARKer:YUNits command sets the Y cursors units:
• BASE — for making measurements in the units associated with the cursors
source.
• PERCent — for making ratio measurements. Use the :MARKer:YUNits:USE
command to set the current Y1 location as 0 percent and the current Y2
location as 100 percent.
Changing Y units affects the input and output values of the :MARKer:Y1Position,
:MARKer:Y2Position, and :MARKer:YDELta commands/queries.
Query Syntax
:MARKer:YUNits?
The :MARKer:YUNits? query returns the current Y cursors units.
Return Format
<units><NL>
<units> ::= {BASE | PERC}
See Also • "Introduction to :MARKer Commands" on page 326
• ":MARKer:YUNits:USE" on page 340
• ":MARKer:X1Y1source" on page 330
• ":MARKer:X2Y2source" on page 332
• ":MEASure:SOURce" on page 380
• ":MARKer:Y1Position" on page 336
• ":MARKer:Y2Position" on page 337
• ":MARKer:YDELta" on page 338
To Next Page
Loading...
Need help?
General
