:WGEN Commands 29
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 697
:WGEN:VOLTage:HIGH
(see page 798)
Command Syntax
:WGEN:VOLTage:HIGH <high>
<high> ::= high-level voltage in volts, in NR3 format
For all waveforms except DC, the :WGEN:VOLTage:HIGH command specifies the
waveform's high-level voltage. Use the :WGEN:VOLTage:LOW command to specify
the low-level voltage.
You can also specify the high-level and low-level voltages indirectly using the
:WGEN:VOLTage and :WGEN:VOLTage:OFFSet commands. For example, a
high-level voltage of 4 V and a low-level voltage of -1 V is the same as an
amplitude of 5 V and an offset of 1 V.
Query Syntax
:WGEN:VOLTage:HIGH?
The :WGEN:VOLTage:HIGH? query returns the currently specified waveform
high-level voltage.
Return Format
<high><NL>
<high> ::= high-level voltage in volts, in NR3 format
See Also • "Introduction to :WGEN Commands" on page 671
• ":WGEN:FUNCtion" on page 673
• ":WGEN:VOLTage:LOW" on page 698
• ":WGEN:VOLTage" on page 696
• ":WGEN:VOLTage:OFFSet" on page 699
To Next Page
Loading...
Need help?
General
