26 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
1 What's New
What's New in Version 2.01
New features in version 2.01 of the InfiniiVision DSOX1204A/G oscilloscope
software are:
• Frequency Response Analysis (FRA) now supports more flexible frequency
ranges in the sweep analysis.
More detailed descriptions of the new and changed commands appear below.
New Commands
Changed
Commands
Obsolete
Commands
Command Description
:FRANalysis:SWEep:POINts
(see page 284)
Specifies the total number of points in the frequency response
analysis.
Command Differences
:FRANalysis:FREQuency:SINGle
(see page 278)
You can now specify precise frequency values between 10 Hz and
20 MHz with a resolution of 0.1 Hz.
:FRANalysis:FREQuency:STARt
(see page 279)
You can now specify precise start frequency values between
10 Hz and 19.99 MHz with a resolution of 0.1 Hz.
:FRANalysis:FREQuency:STOP
(see page 280)
You can now specify precise stop frequency values between
10.1 Hz and 20 MHz with a resolution of 0.1 Hz.
Obsolete Command Current Command Equivalent Behavior Differences
:FRANalysis:PPDecade (see
page 723)
:FRANalysis:SWEep:POINts
(see page 284)
Instead of points-per-decade,
the :FRANalysis:SWEep:POINts
command lets you specify the
total number of points in the
frequency response analysis.
To Next Page
Loading...
Need help?
General
