296 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
17 :FUNCtion Commands
:FUNCtion[:FFT]:VTYPe
(see page 798)
Command Syntax
:FUNCtion[:FFT]:VTYPe <units>
<units> ::= {DECibel | VRMS} for the FFT (magnitude) operation
<units> ::= {DEGRees | RADians} for the FFTPhase operation
The :FUNCtion[:FFT]:VTYPe command specifies FFT vertical units.
Query Syntax
:FUNCtion[:FFT]:VTYPe?
The :FUNCtion[:FFT]:VTYPe? query returns the current FFT vertical units.
Return Format
<units><NL>
<units> ::= {DEC | VRMS} for the FFT (magnitude) operation
<units> ::= {DEGR | RAD} for the FFTPhase operation
See Also • "Introduction to :FUNCtion Commands" on page 291
• ":FUNCtion:OPERation" on page 303
To Next Page
Loading...
