Keysight Technologies InfiniiVision DSOX1204G User Manual

:FRANalysis Commands 16
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 279
:FRANalysis:FREQuency:STARt
(see page 798)
Command Syntax
:FRANalysis:FREQuency:STARt <value>[suffix]
<value> ::= between 10 Hz and 19.99 MHz with a resolution of 0.1 Hz
in NR3 format
[suffix] ::= {Hz | kHz| MHz}
The :FRANalysis:FREQuency:STARt command command sets the frequency sweep
start value.
Query Syntax
:FRANalysis:FREQuency:STARt?
The :FRANalysis:FREQuency:STARt? query returns the frequency sweep start
setting.
Return Format
<value><NL>
See Also • ":FRANalysis:DATA" on page 275
• ":FRANalysis:ENABle" on page 276
• ":FRANalysis:FREQuency:STOP" on page 280
• ":FRANalysis:SWEep:POINts" on page 284
• ":FRANalysis:FREQuency:MODE" on page 277
• ":FRANalysis:RUN" on page 281
• ":FRANalysis:SOURce:INPut" on page 282
• ":FRANalysis:SOURce:OUTPut" on page 283
• ":FRANalysis:WGEN:LOAD" on page 286
• ":FRANalysis:WGEN:VOLTage" on page 287

Keysight Technologies InfiniiVision DSOX1204G Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204G
Category	Test Equipment
Language	English