:TRIGger Commands 27
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 617
:TRIGger:SHOLd:SLOPe
(see page 798)
Command Syntax
:TRIGger:SHOLd:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SHOLd:SLOPe command specifies whether the rising edge or the
falling edge of the clock signal is used.
Query Syntax
:TRIGger:SHOLd:SLOPe?
The :TRIGger:SHOLd:SLOPe? query returns the current rising or falling edge
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 585
• ":TRIGger:MODE" on page 594
• ":TRIGger:SHOLd:SOURce:CLOCk" on page 618
• ":TRIGger:SHOLd:SOURce:DATA" on page 619
To Next Page
Loading...
