:FRANalysis Commands 16
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 275
:FRANalysis:DATA
(see page 798)
Query Syntax
:FRANalysis:DATA?
The :FRANalysis:DATA? query returns the frequency response analysis data.
The data is returned in four comma-separated columns of data for each step in the
sweep: Frequency (Hz), Amplitude (Vpp), Gain (dB), and Phase (°).
Return Format
<binary_block><NL>
<binary_block> ::= comma-separated data with newlines at the end of each
row
See Also • ":FRANalysis:ENABle" on page 276
• ":FRANalysis:FREQuency:STARt" on page 279
• ":FRANalysis:FREQuency:STOP" on page 280
• ":FRANalysis:RUN" on page 281
• ":FRANalysis:SOURce:INPut" on page 282
• ":FRANalysis:SOURce:OUTPut" on page 283
• ":FRANalysis:TRACe" on page 285
• ":FRANalysis:WGEN:LOAD" on page 286
• ":FRANalysis:WGEN:VOLTage" on page 287
To Next Page
Loading...
