Keysight Technologies InfiniiVision DSOX1204G

488 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
24 :SBUS<n> Commands
:SBUS<n>:IIC:TRIGger:PATTern:DATA
(see page 798)
Command Syntax
:SBUS<n>:IIC:TRIGger:PATTern:DATA <value>
<value> ::= integer or <string>
<string> ::= "0xnn" where n ::= {0,..,9 | A,..,F}
The :SBUS<n>:IIC:TRIGger:PATTern:DATA command sets IIC data. The data value
can range from 0x00 to 0x0FF (hexadecimal). Use the don't care data pattern (-1
or 0xFFFFFFFF) to ignore the data value.
Query Syntax
:SBUS<n>:IIC:TRIGger:PATTern:DATA?
The :SBUS<n>:IIC:TRIGger:PATTern:DATA? query returns the current pattern for IIC
data.
Return Format
<value><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":SBUS<n>:IIC:TRIGger:PATTern:ADDRess" on page 487
• ":SBUS<n>:IIC:TRIGger:PATTern:DATa2" on page 489
• ":SBUS<n>:IIC:TRIGger[:TYPE]" on page 491