:SBUS<n> Commands 24
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 513
:SBUS<n>:SPI:SOURce:CLOCk
(see page 798)
Command Syntax
:SBUS<n>:SPI:SOURce:CLOCk <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:SPI:SOURce:CLOCk command sets the source for the SPI serial
clock.
Query Syntax
:SBUS<n>:SPI:SOURce:CLOCk?
The :SBUS<n>:SPI:SOURce:CLOCk? query returns the current source for the SPI
serial clock.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 585
• ":SBUS<n>:SPI:CLOCk:SLOPe" on page 510
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 511
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 514
• ":SBUS<n>:SPI:SOURce:MOSI" on page 516
• ":SBUS<n>:SPI:SOURce:MISO" on page 515
To Next Page
Loading...
