624 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
27 :TRIGger Commands
:TRIGger:TRANsition:SLOPe
(see page 798)
Command Syntax
:TRIGger:TRANsition:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:TRANsition:SLOPe command specifies a POSitive rising edge or a
NEGative falling edge.
Query Syntax
:TRIGger:TRANsition:SLOPe?
The :TRIGger:TRANsition:SLOPe? query returns the current rise/fall time trigger
slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 585
• ":TRIGger:MODE" on page 594
• ":TRIGger:TRANsition:SOURce" on page 625
To Next Page
Loading...
