208 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
10 :CHANnel<n> Commands
:CHANnel<n>:IMPedance
(see page 798)
Command Syntax
:CHANnel<n>:IMPedance <impedance>
<impedance> ::= ONEMeg
<n> ::= 1 to (# analog channels) in NR1 format
The :CHANnel<n>:IMPedance command selects the input impedance setting for
the specified analog channel. The only legal value for this command is ONEMeg
(1 M
Ω).
Query Syntax
:CHANnel<n>:IMPedance?
The :CHANnel<n>:IMPedance? query returns the current input impedance setting
for the specified channel.
Return Format
<impedance value><NL>
<impedance value> ::= ONEM
See Also • "Introduction to :CHANnel<n> Commands" on page 203
To Next Page
Loading...
