278 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
16 :FRANalysis Commands
:FRANalysis:FREQuency:SINGle
(see page 798)
Command Syntax
:FRANalysis:FREQuency:SINGle <value>[suffix]
<value> ::= between 10 Hz and 20 MHz with a resolution of 0.1 Hz
in NR3 format
[suffix] ::= {Hz | kHz| MHz}
The :FRANalysis:FREQuency:SINGle command command sets the single frequency
value.
Query Syntax
:FRANalysis:FREQuency:SINGle?
The :FRANalysis:FREQuency:SINGle? query returns the single frequency setting.
Return Format
<value><NL>
See Also • ":FRANalysis:DATA" on page 275
• ":FRANalysis:ENABle" on page 276
• ":FRANalysis:SWEep:POINts" on page 284
• ":FRANalysis:FREQuency:MODE" on page 277
• ":FRANalysis:RUN" on page 281
• ":FRANalysis:SOURce:INPut" on page 282
• ":FRANalysis:SOURce:OUTPut" on page 283
• ":FRANalysis:WGEN:LOAD" on page 286
• ":FRANalysis:WGEN:VOLTage" on page 287
The SINGle mode is available through the remote programming interface only and is not
available when using the front panel graphical user interface (GUI).
To Next Page
Loading...
Need help?
General
